Gigabyte W480 VISION D - Chapter 6 Appendix; Configuring Audio Input and Output; Configuring 2;4;5.1;7.1-Channel Audio

Appendix
- 99 -
Chapter 6 Appendix
6-1 ConguringAudioInputandOutput
6-1-1 Conguring2/4/5.1/7.1-ChannelAudio
The motherboard provides five audio jacks on the back
panelwhich support 2/4/5.1/7.1-channel
(Note)
audio.
The picture to the right shows the default audio jack
assignments.
After you install the included motherboard drivers, make sure your Internet connection works properly. The system
willautomaticallyinstalltheaudiodriverfromMicrosoftStore.Restartthesystemaftertheaudiodriverisinstalled.
Center/Subwoofer
Speaker Out
Line In
RearSpeakerOut
Front Speaker Out
A. Configuring Speakers
Step 1:
Go to the Start menu click the Realtek Audio Console.
For speaker connection, refer to the instructions
in Chapter 1, "Hardware Installation," "Back Panel
Connectors."
Toconfigure4/5.1/7.1-channelaudio,youhavetoretaskeithertheLineinorMicinjacktobeSide
speaker out through the audio driver.
Step 2:
Connect an audio device to an audio jack. The Which
device did you plut in ? dialog box appears. Select
the device according to the type of device you connect.
Then click OK.