Gigabyte W480 VISION D - Page 55

BIOS Setup
- 55 -
 Smart Fan 5
& Monitor
Allows you to select a target to monitor and to make further adjustment. (Default: CPU FAN)
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the temperature. You can adjust the fan
speed with System Information Viewer based on your system requirements. (Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed in the curve graph.
Full Speed Allows the fan to run at full speeds.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
& Fan/Pump Control Mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode. (Default)
Voltage  Voltagemodeisrecommendedfora3-pinfan/pump.
PWM   PWMmodeisrecommendedfora4-pinfan/pump.
& Fan/Pump Stop
 Enablesordisablesthefan/pumpstopfunction.Youcansetthetemperaturelimitusingthetemperature
curve. The fan or pump stops operation when the temperature is lower than the limit. (Default: Disabled)
& Temperature
Displays the current temperature of the selected target area.
& Fan Speed
 Displayscurrentfan/pumpspeeds.
& Flow Rate
 Displaystheowrateofyourwatercoolingsystem.
& Temperature Warning Control
Sets the warning threshold for temperature. When temperature exceeds the threshold, BIOS will emit
warning sound. Options are: Disabled (default), 60
o
C/140
o
F, 70
o
C/158
o
F, 80
o
C/176
o
F, 90
o
C/194
o
F.
& Fan/Pump Fail Warning
 Allowsthesystemtoemitwarningsoundifthefan/pumpisnotconnectedorfails.Checkthefan/pump
conditionorfan/pumpconnectionwhenthisoccurs.(Default:Disabled)