EasyManua.ls Logo

Gigabyte X299 UD4 Pro - Additional Fan;Pump Headers; Temperature and SATA Connectors

Gigabyte X299 UD4 Pro
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5) CPU_OPT (Water Cooling CPU Fan Header)
The fan header is 4-pin and possesses a foolproof insertion design. Most fan headers possess a foolproof
insertion design. When connecting a fan cable, be sure to connect it in the correct orientation (the black
connector wire is the ground wire). The speed control function requires the use of a fan with fan speed
control design.
DEBUG
PORT
G.QBOFM
1
6) HPWR_FAN_PUMP (3 Amp Fan/Water Cooling Pump Header)
The fan/pump header is 4-pin and possesses a foolproof insertion design. Most fan headers possess a
foolproof insertion design. When connecting a fan cable, be sure to connect it in the correct orientation
(the black connector wire is the ground wire). The speed control function requires the use of a fan with fan
speed control design. The header also provides speed control for a water cooling pump, refer to Chapter
2,"BIOSSetup,""M.I.T.,"formoreinformation
Pin No. Denition
1
GND
2
Voltage Speed Control
3
Sense
4
PWM Speed Control
Pin No. Denition
1
GND
2
Voltage Speed Control
3
Sense
4
PWM Speed Control
1
DEBUG
PORT
G.QBOFM
Because a 3 Amp fan can run very fast, DO NOT touch it when it is operating to avoid injury.
7) EC_TEMP1 (Temperature Sensor Header)
Connect the thermistor cable to the header for temperature detection.
Pin No. Denition
1 SENSORIN
2 GND
1
8) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
®
ChipsetsupportsRAID0,
RAID1,RAID5,andRAID10.RefertoChapter3,"ConguringaRAIDSet,"forinstructionsonconguring
aRAIDarray.
1
1
SATA3
7 5 3 1
6 4 2 0
7
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
7
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Toenablehot-pluggingfortheSATAports,refertoChapter2,"BIOSSetup,""Peripherals\SATA
AndRSTConguration,"formoreinformation.
- 16 -

Related product manuals