Gigabyte X299 UD4 Pro - Back Panel Connectors; Onboard LEDs

USB  Chipset+ASMedia
®
USB 3.1 Gen 2 Controller:
- 2 x USB 3.1 Gen 2 Type-A ports (red) on the back panel
 Chipset:
- 10 x USB 3.1 Gen 1 ports (6 ports on the back panel, 4 ports available through
the internal USB headers)
- 4 x USB 2.0/1.1 ports available through the internal USB headers
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x CPU fan header
 1 x water cooling CPU fan header
 2 x system fan headers
 1 x 3 Amp fan/water cooling pump header
 1 x digital LED strip header
 1 x digital LED strip power select jumper
 2xRGB(RGBW)LEDstripextensioncableheaders
 2 x M.2 Socket 3 connectors
 8 x SATA 6Gb/s connectors
 1 x Intel
®
VROCUpgradeKeyheader
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 2 x USB 3.1 Gen 1 headers
 2 x USB 2.0/1.1 headers
 1 x Thunderbolt
™
add-in card connector
 1 x Trusted Platform Module (TPM) header
 1 x temperature sensor header
 1 x Clear CMOS jumper
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 2 x USB 3.1 Gen 2 Type-A ports (red)
 6 x USB 3.1 Gen 1 ports
 1xRJ-45port
 6xaudiojacks(Center/SubwooferSpeakerOut,RearSpeakerOut,SideSpeaker
Out, Line In, Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Watercoolingowratedetection
 Overheating warning
 Fan fail warning
 Fan speed control
* Whether the fan (pump) speed control function is supported will depend on the fan
(pump) you install.
- 7 -