Gigabyte X470 AORUS GAMING 7 WIFI - Page 19

10) D_LED1/D_LED2 (Digital LED Strip Headers)
The headers can be used to connect a standard 5050 digital LED strip, with maximum power rating of 2A
(12V or 5V) and maximum length of 5m or maximum number of 300 LEDs. There are 12V and 5V digital
LED strips. Be sure to verify the voltage requirements of your digital LED strip and set the DLED_V_SW1
and DLED_V_SW2 jumpers accordingly.
Pin No. Denition
1 V
2 D
3 G
1
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
The power pin (marked with a
triangle on the plug) of the LED
strip must be connected to Pin 1
of the digital LED strip header.
Incorrect connection may lead
to the damage of the LED strip.
Digital LED Strip
1
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 2, "BIOS
Setup," "Peripherals."
11) DLED_V_SW1/DLED_V_SW2 (Digital LED Strip Power Select Jumpers)
The jumpers allow you to select the supply voltage of the D_LED1 and D_LED2 headers. Be sure to
verify the voltage requirements of your digital LED strip and set the correct voltage with this jumper before
connection. Incorrect connection may lead to the damage of the LED strip.
1
1
1-2: 5V 1-2: 5V
2-3: 12V 2-3: 12V
D_LED1
DLED_V_SW1
D_LED2
1
1
1
DLED_V_SW2
Connecting a 3-pin digital LED strip:
Connect one end of the included
digital LED strip adapter cable to
this header and the other end to
your digital LED strip. The triangle
marking on the plug of the adapter
cable must be connected to Pin 1 of
the header. The "V" pin of the other
end of the adapter cable must be
connected to the power pin (marked
with a triangle) of the LED strip.
Incorrect connection may lead to the
damage of the LED strip.
Digital LED Strip
Connecting a 4-pin digital LED strip (using the included digital LED strip
adapter cable):
GDV
1
GDV
- 19 -