Gigabyte Z390 AORUS XTREME - Creating RAID Arrays (EZ RAID, UEFI, Legacy)

- 69 -
Conguring a RAID Set
C-1. Using EZ RAID
GIGABYTEmotherboardsprovideyouwiththeEZRAIDfeature,allowingyoutoquicklycongureaRAID
arraywithsimpliedsteps.
Step 1:
After restarting the computer, enter the BIOS Setup and go to Peripherals. Press <Enter> on the EZ RAID item.
Select the type of hard drives you use for RAID in the Type tab and then press <Enter>. (Figure 2)
Figure 2
Figure 3
Step 2:
Go to the Mode tab to select a RAID level. RAID levels supported include RAID 0, RAID 1, RAID 10, and RAID 5
(the selections available depend on the number of the hard drives being installed). Then press <Enter> to move
to the Create tab. Click Proceed to begin (Figure 3).