Gigabyte Z590 AORUS XTREME - Page 42

BIOS Setup
- 42 -
& FAN/PUMP Stop
 Enablesordisablesthefan/pumpstopfunction.Youcansetthetemperaturelimitusingthetemperature
curve. The fan or pump stops operation when the temperature is lower than the limit. (Default: Disabled)
& FAN/PUMP Mode
Allows you to set the operating mode for the fan.
Slope Adjusts the fan speed linearly based on the temperature. (Default)
Stair Adjusts the fan speed stepwise based on the temperature.
& FAN/PUMP Fail Warning
 Allowsthesystemtoemitwarningsoundifthefan/pumpisnotconnectedorfails.Checkthefan/pump
conditionorfan/pumpconnectionwhenthisoccurs.(Default:Disabled)
& SaveFanProle
 Thisfunctionallowsyoutosavethecurrentsettingstoaprole.YoucansavetheproleintheBIOSor
select Select File in HDD/FDD/USBtosavetheproletoyourstoragedevice.
& LoadFanProle
 ThisfunctionallowsyoutoloadapreviouslysavedBIOSprolewithoutthehasslesofreconguringthe
BIOS settings. Or you can select Select File in HDD/FDD/USBtoloadaprolefromyourstoragedevice.