Gigabyte Z590 AORUS XTREME - Smart Fan 6

BIOS Setup
- 41 -
2-3 Smart Fan 6
Usethe<F6>functionkeytoquicklyswitchtothisscreen.Thisscreenallowsyoutocongurefanspeedrelated
settingsforeachfanheaderormonitoryoursystem/CPUtemperature.
& TUNE ALL
Allows you to apply the current settings to all fan headers.
& Temperature
Displays the current temperature of the selected target area.
& Fan Speed
 Displayscurrentfan/pumpspeeds.
& Flow Rate
 Displaystheowrateofyourwatercoolingsystem.Press<Enter>onFan Speed to switch to this function.
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the temperature. You can adjust
the fan speed with System Information Viewer based on your system requirements.
(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to drag the curve nodes to adjust fan speed. Or you can use the EZ Tuning
feature. After adjusting the node position, press Apply to automatically calculate the
slope of the curve.
Full Speed Allows the fan to run at full speeds.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
& FAN/PUMP Control Mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode. (Default)
Voltage  Voltagemodeisrecommendedfora3-pinfan/pump.
PWM   PWMmodeisrecommendedfora4-pinfan/pump.