Gigabyte Z590 VISION D - Page 12

- 12 -
Hardware Installation
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x 4-pin ATX 12V power connector
 1 x CPU fan header
 1 x water cooling CPU fan header
 4 x system fan headers
 2xsystemfan/watercoolingpumpheaders
 2 x addressable LED strip headers
 2xRGBLEDstripheaders
 3 x M.2 Socket 3 connectors
 6xSATA6Gb/sconnectors
 1 x front panel header
 1 x front panel audio header
 1 x USB Type-C
®
header, with USB 3.2 Gen 2x2 support
 1 x USB 3.2 Gen 1 header
 2xUSB2.0/1.1headers
 1 x noise detection header
 1xTrustedPlatformModuleheader(FortheGC-TPM2.0SPI/GC-TPM2.0SPI
2.0 module only)
 2 x temperature sensor headers
 1 x Clear CMOS jumper
 1 x Q-Flash Plus button
Back Panel
Connectors
 1 x DisplayPort In port
 1 x HDMI port
 2xSMAantennaconnectors(2T2R)
 2 x Thunderbolt
™
4 connectors (USB Type-C
®
port, with USB 3.2 Gen 2 support)
 2 x USB 3.2 Gen 2 Type-A ports (red)
 4 x USB 3.2 Gen 1 ports
 2xRJ-45ports
 1xopticalS/PDIFOutconnector
 5 x audio jacks
I/OController  iTE
®
I/OControllerChip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Watercoolingowratedetection
 Fan fail warning
 Fan speed control
* Whetherthefan(pump)speedcontrolfunctionissupportedwilldependonthefan
(pump) you install.
 Noise detection
BIOS  1x256Mbitash
 Use of licensed AMI UEFI BIOS
 PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0