Gigabyte Z590 VISION D - Chapter 6 Appendix; Configuring Audio Input and Output

- 91 -
Appendix
Chapter 6 Appendix
6-1 ConguringAudioInputandOutput
6-1-1 Conguring2/4/5.1/7.1-ChannelAudio
The motherboard provides five audio jacks on the
backpanelwhich support 2/4/5.1/7.1-channel audio.
The picture to the right shows the default audio jack
assignments.
After you install the included motherboard drivers, make sure your Internet connection works properly. The system
willautomaticallyinstalltheaudiodriverfromMicrosoftStore.Restartthesystemaftertheaudiodriverisinstalled.
A. Configuring Speakers
Step 1:
Go to the Start menu click the Realtek Audio Console.
For speaker connection, refer to the instructions
in Chapter 1, "Hardware Installation," "Back Panel
Connectors."
Toconfigure4/5.1/7.1-channel audio,youhave toretask the Linein jacktobe Sidespeakerout
through the audio driver.
Step 2:
Connect an audio device to an audio jack. The Which
device did you plut in ? dialog box appears. Select
the device according to the type of device you connect.
Then click OK.
Center/Subwoofer
Speaker Out
Line In
RearSpeakerOut
Front Speaker Out
Mic In