Gigabyte Z590 VISION D - Page 73

- 73 -
Conguring a RAID Set
B. Rebuilding an Array
Rebuildingistheprocessofrestoringdatatoaharddrivefromotherdrivesinthearray.Rebuildingappliesonly
tofault-tolerantarrayssuchasRAID1,RAID5orRAID10arrays.Theproceduresbelowassumeanewdrive
isaddedtoreplaceafaileddrivetorebuildaRAID1array.(Note:Thenewdrivemusthaveequalorgreater
capacity than the old one.)
Turnoffyourcomputerandreplacethefailedharddrivewithanewone.Restartyourcomputer.
While in the operating system, launch the Intel
®
Optane
™
Memory and Storage Management utility from the
Start menu.
Step 1:
Go to the Manage menu and click Rebuild to another
disk in Manage Volume.
The Status item on the right of the screen displays the
rebuildprogress.AftertheRAID1volumerebuilding,
the Status will display as Normal.
Step 2:
Selecta new drive to rebuildthe RAID and click
Rebuild.