Gigabyte Z590M - Smart Fan 6 Configuration

Usethe<F6>functionkeytoquicklyswitchtothisscreen.Thisscreenallowsyoutocongurefanspeedrelated
settings for each fan header or monitor your system/CPU temperature.
& TUNE ALL
Allows you to apply the current settings to all fan headers.
& Temperature
 Displaysthecurrenttemperatureoftheselectedtargetarea.
& Fan Speed
 Displayscurrentfanspeeds.
& Fan Speed Control
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal  Allowsthefantorunatdifferentspeedsaccordingtothetemperature.Youcanadjust
the fan speed with System Information Viewer based on your system requirements.
(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to drag the curve nodes to adjust fan speed. Or you can use the EZ Tuning
feature. After adjusting the node position, press Apply to automatically calculate the
slope of the curve.
Full Speed Allows the fan to run at full speeds.
& Fan Control Use Temperature Input
Allows you to select the reference temperature for fan speed control.
& Temperature Interval
Allows you to select the temperature interval for fan speed change.
& FAN Control Mode
Auto Lets the BIOS automatically detect the type of fan installed and sets the optimal control
mode.(Default)
Voltage Voltage mode is recommended for a 3-pin fan.
PWM PWM mode is recommended for a 4-pin fan.
& FAN Stop
Enables or disables the fan stop function. You can set the temperature limit using the temperature curve.
Thefanorpumpstopsoperationwhenthetemperatureislowerthanthelimit.(Default:Disabled)
2-3 Smart Fan 6
- 23 -