Gigaset N870 User Manual

Home
PBXware
SERVERware
TELCOware
SIPmon
SIPProt
Desktop & Mobile
BRM
UADs
Appliances
EOL
From Bicom Systems Wiki
Contents
1 Introduction
■
2 Requirements
■
2.1 Identifying phone model
■
2.2 Phone firmware
■
2.3 DHCP server
■
2.4 PBXware version
■
3 Installation
■
3.1 Power adapter
■
3.2 Power over Ethernet (PoE)
■
3.3 Find the phone IP address
■
3.4 Reset to factory settings
■
4 Registering phone
■
4.1 Manual configuration
■
4.2 Auto Provisioning
■
Introduction

Gigaset N870 Specifications

General

PoE Standard	802.3af
Max Concurrent Calls Per Base Station	8
Network Protocols	RTP
Security	TLS
Power Supply	PoE IEEE 802.3af, Class 3
Management	Web-based configuration, Auto-provisioning
Codecs	G.711, G.722, G.726, G.729
DECT Standards	DECT CAT-iq 2.0, GAP
Handset	Yes
Speakerphone	Yes
Number of SIP Accounts	8

Summary

Requirements

Identifying phone model

Identify the specific Gigaset phone model for successful registration and setup.

Phone firmware

Ensure the phone is loaded with the correct firmware version for compatibility.

DHCP server

A fully configured and operational DHCP server is required for network setup.

PBXware version

Verify the PBXware version to ensure compatibility with the phone.

Installation

Power adapter

Connect the phone to power using the DC plug and an electrical outlet.

Power over Ethernet (PoE)

Power the phone using a PoE-compliant router or switch via Ethernet.

Find the phone IP address

Locate the phone's IP address through its menu system for configuration.

Reset to factory settings

Reset the phone to factory defaults if it has been previously used.

Registering phone

Manual configuration

Configure phone settings manually for registration with PBXware.

UAD settings

Configure Universal Appliance Device (UAD) settings for the Gigaset phone.

Creating extension

Create a new extension in PBXware for the Gigaset phone.

Hostname or IP Address

Register the phone using its hostname or IP address via web interface.

Auto Provisioning

UAD Settings

Enable and configure UAD settings for automatic phone provisioning.

Creating Extension

Create a PBXware extension to be used for auto-provisioning.

Registering Phone

Register the phone using auto-provisioning via DHCP or HTTP.

DHCP

Configure DHCP router options for automatic phone provisioning.

HTTP

Configure HTTP settings for auto-provisioning, including digest credentials.