MDE-2713C Universal Distribution Box (D-Box) Installation Manual · August 2016 Page 1
Introduction
Purpose
This manual provides installation information for the Universal Distribution Box (D-Box)
PA0261. The D-Box provides an interface between Gilbarco
®
consoles with Two-wire Current
Loop Interface (TWI) and dispensing units or Passport
®
controllers with RS-422 interface and
dispensing units, CRIND
®
s, or G-CAT
™
s. This D-Box works with all Gilbarco electronic fuel
dispensing consoles and controllers.
This manual also provides the inst
allation instructions for the Expansion Kit [K93717 (only
for T17651 Board)]. The kit allows you to add a second distribution board to the D-Box.
Intended Users
This manual is intended for Gilbarco-trained and certified Authorized Service Contractors
(ASCs).
Do not install this equipment unless you have proper training for installing equipment in a
hazardous location.
WARNING
Table of Contents
Topic Page
Introduction 1
Important Safety Information 4
Before You Begin 6
Installing Universal D-Box 6
Required Tools and Materials
Following tools and materials are required for installing the universal D-Box:
• Drill
• Multimeter
• Needle Nose Pliers
• Flat-blade and Phillips
®
-head Screwdriver #2
• Wire Nuts
•Wire Stripper
MDE-2713C
Universal Distribution Box (D-Box)
Installation Manual
August 2016
To Next Page
Need help?
General
