●
Connect the riser to the harness carabiners. Make sure that the carabiners are closed and
that nothing is twisted.
●
Connect the speed system of the riser and harness with the Brummel hooks.
●
Check one last time that there are no knots in the lines, nothing is twisted and that the lines
are not caught in vegetation or rocks. You must be particularly attentive in lighter winds.
WARNING: If there are obvious creases in the glider as a result of tight packing or long term
storage, carry out some practice inflations before your first launch and smooth out the
trailing edge a little. This ensures that the flow profile is correct during launch. This is
particularly important in low temperatures.
5-point check
The 5-point check is carried out immediately before launch to check the most important safety points
once again. It should always be carried out in the same sequence so that nothing is overlooked. The 5
points are:
1. Is your personal equipment in order (harness, carabiners, reserve, helmet), all straps done up?
2. Is the canopy arranged in a half-moon shape and are all the air intakes open?
3. Are all the lines untangled and are any lines under the canopy?
4. Does the weather, in particular wind direction and strength, allow a safe launch?
5. Are the airspace and launch area clear?
Launching
The key to a successful launch technique is to practice ground handling on flat ground whenever you
can. The Evora has good inflation and launch characteristics for its class, and no special launch
techniques are required.
Forward inflation
We recommend a forward inflation in nil to light winds. Pull up the glider with the lines stretched. It is
not necessary to use any momentum to launch the Evora and/or to start running with slack lines.
Lean forward positively and guide the ‘A’ risers smoothly upwards in an arc, keeping your elbows
bent and hands at the level of the shoulders. The Evora will inflate easily—there is no need to
aggressively pull or push the risers. As the glider comes above your head, make sure that the canopy
is correctly inflated, and that there are no knots or tangles in the lines before you decide to take-o
ff
. If
you see a disturbance, do not launch. Immediately abort the take-o
ff
by stalling the paraglider. If the
slope is steep, then just pull through one brake completely and run parallel to the slope.
Reverse inflation
The Evora is suitable for reverse inflation in light to strong winds. We suggest that you partially inflate
your canopy, which allows you to untangle the lines. Make sure the lines are free from knots or
tangles. Check that the airspace and visibility are clear. Gently pull up the glider in an arc with the ‘A’
risers. When the glider is overhead, brake it gently if necessary, turn around and launch. If the wind is
very strong, it is recommended to make a few steps toward the wing when inflating.
This method of inflation makes it easier for the pilot to control the rising of the canopy and is
therefore recommended in strong winds.
To Next Page
Loading...
