Gin X - Getting Your GIN X Road Ready; Handlebar, Tyre, and Headlight Setup

28 pages

To Next Page

To Previous Page

Getting your GIN X road ready!

Step 1 : Installing the handlebar

Step 2 : Installing your front tyre

Step 3 : Inflating the front tyre (to 40 psi air pressure)

Step 4 : Installing the front headlight

Step 5 : Installing the pedals

Step 6 : Installing the seat post

Step 7 : Installing the display monitor

Step 8 : Installing the battery

Step 9 : Installing the rear cargo rack

Step 1 : Installing the handlebar

1.1 Make sure that you tighten the

screws of the cockpit bar. If it comes

assembled then please tighten the

screws. They might have come loose

while shipping

1.2 Tighten the screws surrounding

the spacers

1.3 You can remove the spacers if you

need to decrease or increase the height

of the handle bar