Operating & Adjusting your Scooter
Turning your Scooter ON/OFF
To turn the scooter on, insert the key and turn clockwise. To turn your
scooter off, turn the key counterclockwise from the on position. The LCD
display should activate and “Ready” light illuminate indicating the scooter is
on and ready to ride. Your scooter can also be turned on & off remotely with
the included key fob, see further instructions on pg 12. Once the scooter is
turned on using a specific method (keys or fob) it can ONLY be turned off
with the same method.
Driving your Scooter
The Titan PR features a variable twist throttle on the right handlebar. (See
steering controls diagram) Gently twist the throttle grip inwards to slowly
accelerate to the desired speed. Avoid twisting too hard or too quickly as
this may result in jumps in accelerations making steering less controllable.
To slow or stop your scooter, release the throttle and squeeze both brake
levels to apply both front and rear brakes. Always apply both brakes at the
same time, especially when traveling at higher speeds. Please note the
electric braking function of your scooter will prevent the motor from starting
if the brakes are applied.
⚠ Drive with care on wet/slippery/icy surfaces as it will increase the
distance needed to stop, allow extra room for braking in these
conditions. When driving downhill it is recommended to release the
throttle & apply brakes as needed to control the scooter’s speed. ⚠
⚠ Please note your scooter can be converted from miles to
kilometers via a wired connection near the bottom edge of the
handlebar cover piece. Connect or disconnect this connection to set
to your desired unit of measurement & tuck back under the cover. ⚠
11
To Next Page
Loading...
Need help?
General
