Your scooter features control switches next to the throttle grip that adjust
driving features. The lower switch labeled RND sets the scooter into
reverse, neutral or forward drive. The red switch labeled 1-3 sets the current
speed setting of the forward drive when in use. Bring your scooter to a
complete stop before switching between forward, neutral and reverse.
Speeds by level:
I - 5 mph (8 km/h) II - 10 mph (6 km/h) Speed III - 15 mph (24 km/h)
Reverse - 3 mph (5 km/h)
The brake lever also features a parking brake option. Once stopped you can
apply the parking brake by firmly squeezing the rear(left) brake lever as if
you were applying the brakes to stop. Then with your other hand reach
below and behind the lever and push the brake locking pin (silver in color
with rubber cap) upwards into the level to secure it. To release the parking
brake simply squeeze the brake lever again, the pin should slip downwards
releasing the secured brake lever. If it doesn’t unlock freely, manually assist
the pin’s withdrawal. Always attempt to park on a level surface if possible.
Using the electric features of you Scooter
Your scooter has several features that have controls also located on either
side of the display screen. (See control diagram for locations)
Right Side Controls
The uppermost switch labeled with ⟁ toggles the brake lights of your scooter
on and off. Please note: that pressing this button also engages the motor
power cut off feature.
The center sliding switch controls the scooters lights:
( ☼ ) All lights including headlight ON
(>DⱭ<) Daytime signal & running lights only or
( ○ ) All lights OFF
12
To Next Page
Loading...
Need help?
General
