7
All electrical conductors
MUST BE PROTECTED
against the water jet.
SHORT CIRCUIT
HAZARD
The appliance
MUST ONLY BE CONNECTED
to an adequate power supply in
compliance with all applicable regulations.
ELECTRIC SHOCK HAZARD
MUST
use of a safety residual current circuit-breaker (R.C.C.B) will provide
additional protection for the operator.
Appliance without plug
MUST
be installed by qualified staff. Use only authorized
electrical extension leads with suitable conductor gauge.
High pressure may cause parts to rebound: wear all the protective clothing and
equipment
MUST
need to ensure the operator’s safety.
INJURY HAZARD
Plug
MUST
be pulled out after shutting the appliance or the appliance might start
automatically or burn itself.
MUST
hold the gun firmly before triggering it.
INJURY HAZARD
MUST
comply with the requirements of the local water supply company. According
to EN 12729(BA), the appliance may only be connected to the mains drinking water
supply if a back flow prevented valve with drain facility is installed in the supply hose.
CONTAMINATION HAZARD
Maintenance or repair of electrical components
MUST
be carried out by qualified staff.
ACCIDENT HAZARD
MUST
Shut down the appliance, cut power supply and water supply. Then, discharge
the residual pressure by triggering the gun before disconnecting the unit hose.
INJURY HAZARD
Before using the appliance,
MUST
check every time that the screws are fully tightened
and that there are no broken or worn parts.
ACCIDENT HAZARD
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
SAFETY “MUSTS”
To Next Page
Loading...