EasyManuals Logo

Girard Products GSWH-1 Installation Manual

Girard Products GSWH-1
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1361 Calle Avanzado, San Clemente, CA 92673, Phone 949.259-4000 Fax 949.276-5500 www.greenrvproducts.com
TANKLESS WATER HEATER Model GSWH-1
INSTALLATION MANUAL ADDENDUM for after Market Installations
REPLACEMENT OF AN ATWOOD 6 GA. UNIT
DOOR/FLANGE ASSEMBLY - Part #1GWHDA6
Fig. 1
The existing cut out for a 6 gal Atwood water heater measures 16 1/4 (W) by 12 5/8” (H).
The cut out needed for your GSWH-1 is only 12 ¾” by 12 ¾” and its flange MUST be supported on all
sides by a wooden frame so that it may be mounted rigidly with #8 ¾” flat head screws.
The flange will fit vertically into the existing opening, but a horizontal gap of 3 ½” will be left between
the new flange and the side of the opening.
A properly cut piece of 2” by 2” must be added as a vertical brace located at 12 ¾” from the right edge
of the cut out. (See Fig. 1)
Please refer to the Owner’s Manual for information on how to complete the installation.
Vertical brace

Other manuals for Girard Products GSWH-1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Girard Products GSWH-1 and is the answer not in the manual?

Girard Products GSWH-1 Specifications

General IconGeneral
BrandGirard Products
ModelGSWH-1
CategoryWater Heater
LanguageEnglish

Related product manuals