To Next PageTo Next Page
Need help?Do you have a question about the Girard Products GSWH-1 and is the answer not in the manual?
General| Type | Tankless |
|---|---|
| Fuel Type | Propane |
| Capacity | Continuous |
| Ignition | Electronic |
| Water Connection | 1/2" NPT |
| Ignition Type | Electronic |
| Venting | Direct Vent |
Identifies the model GSWH-1 and its type as a tankless water heater.
Highlights safety cautions and certification logos like CSA and US.
Outlines duties for installation and service personnel and owners.
Details critical warnings and procedures in case of gas leaks or fire hazards.
Lists essential prohibitions and guidelines for installing the water heater.
Refers to national and local codes to follow for installation compliance.
Provides guidelines for choosing a suitable and safe installation location.
Specifies areas where the water heater must not be installed due to venting or enclosure issues.
Details the dimensions and framing needed for the installation opening.
Warns against improper lifting methods that could misalign components.
Guides on connecting water and gas lines, including damage prevention.
Stresses not shortening external wires to ensure future servicing access.
Step-by-step instructions for installing the unit using a separate flange.
Step-by-step instructions for installing the unit with an integral flange.
Details how to connect the remote mode switch for operation control.
Outlines steps to verify the unit's operation after installation.
Guides on correctly installing and closing the unit's door.
Lists essential safety rules for using propane gas.
Covers safe practices like shutting off gas when moving the vehicle.
Explains the induced-draft, tankless design and Dual BTU burner.
Details how to turn on the unit and adjust temperature using the faucet.
Describes the user panel controls like the power switch and LED indicator.
Explains how water flow affects temperature and the function of the safety limit switch.
Provides methods to prepare the unit for freezing temperatures.
Details the function, warnings, and replacement of the safety relief valve.
Lists monthly and yearly inspection tasks for optimal performance.
Explains how to check the burner flame for proper combustion.
Describes the sequence of events from faucet activation to ignition.
Explains common failures and how the LED indicator signals diagnostic codes.
Breaks down the unit into Water, Gas, Flue, and Electrical sub-systems.
Illustrates the unit with major components labeled.
Presents the electrical wiring diagram showing interconnections and wire colors.
Shows the control logic and functionality of electrical components.
Lists key performance specifications like BTU, pressure, and dimensions.
Details the duration, coverage, and conditions of the product warranty.
Specifies conditions under which the warranty is void or does not apply.
Outlines how to obtain service and contact the manufacturer.
Clarifies intended use and actions that void the warranty.
