Page 5 of 14
PAIRING WITH REMOTE DEVICES
The following pages give instructions on how to pair the GC1146C Motor controller with
various compatable RF remote control devices. Please ensure that the correct set of
instructions are followed for the device being paired with the Motor controller.
GC660B SINGLE CHANNEL WALL SWITCH
The faceplate can be removed easily by holding the module firmly in one hand at the
left and right edges and push the STOP button with two fingers of your other hand.
Fig.1 below shows how the batteries must be inserted.
Fig.1 Fig.2
When pairing with the GC1146C it is advised that the awning to be controlled is
manually extended couple of feet to enable the programmer to see if the awning is
responding in the correct direction when the buttons on the wall switch are pressed.
The programming window for this module is only 10 seconds so please
ensure that the programming instructions are read and understood before
attempting to execute them.
1) Supply power to the motor control module. (It will beep ONCE).
2) Press the P2 button on the wall switch TWICE. (The motor controller will beep
with each press)
3) Press the IN button on the wall switch. (The awning should retract)
To Next Page
Loading...