The Equipment named above is confirmed to comply with the requirements setout in the European Council Directive on the Approximation of the Laws of the
Member States relating to RED (2014/53/EU). The equipment passed the test which was performed according to the following European standards:
EN 300 328 V2.1.1; EN 301 893 V2.1.0; EN 300 440 V2.1.1
EN 301 489-1 V2.1.1; EN 301 489-17 V3.1.1
IEC/EN 62368-1:2014 (Second Edition)
IEC/EN 60065:2014 (Eighth Edition)
EN 60950-1:2006 (Second Edition) + A1:2010 + A2:2013
This product uses WiFi
2.4GHz Operating Frequency is 2400~2483.5MHz; 5GHz Operating Frequency is 5150 ~ 5250MHz and 5725 ~ 5850MHz;
RF Exposure: The highest measured 1g (simultaneous transmission)
Manufacturer: GL Technologies (Hong Kong) Limited, Unit 210D, 2/F, Enterprise Place Hong Kong Science Park, Shatin, N.T,
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,and
(2) This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the users’ authority to operate the equipment.
3. The minimum separation generally be used is at least 20 cm, even if the calculations indicate that the MPE distance would be lesser.
4. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC ID: 2AFIW-AR750
To Previous Page
Loading...
Need help?
General