4
Points to Installer
X
Y
INSTALLATION TO BE PERFORMED BY QUALIFIED PROFESSIONAL ONLY.
Wall hung vanity cabinets require important wall preparation and installation. Please thoroughly read this notice and all other installation
instructions that might be included with the cabinetry.
Keep in mind
□ Cabinets must be securely fastened with sufcient type, quantity and size of screws to wall studs and internal structural wall blocking.
□ See below for examples and instructions for internal structural wall blocking necessary for proper installation
Internal wall blocking installation
□ A horizontal row of wood 2 X 7 structural wall blocks are required and must be installed between wall studs at a height to match
where the top of the wall hung vanity cabinets will be installed. Carefully remove drywall in required locations to gain access to wall
studs. Use caution to not disturb any electrical or plumbing utilities found within the wall.
□ Install a second row of 2 X 7 structural wall blocks to match the height of the cabinets to allow fastening near the bottom.
□ The 2 X 7 structural wall blocks should be positioned between each wall stud where the cabinets will be located.
□ Use wood screws installed at an angle to securely fasten the structural wall blocks to the wall studs.
WARNING
Serious or fatal injuries can occur should unit fail.
To prevent failure:
□ Do not sit, stand, lean or climb on unit.
□ Do not lay or sit beneath unit.
□ Do not set heavy objects on the top of the unit, overload unit or overload drawers.
□ Do not open more than one drawer at a time.
X - Required height for top of
the cabinet from the oor.
Y - Required distance to
match the cabinet height.
To Next Page
Loading...
Need help?
General
