www.goedlichtengeluid.nl info@goedlichtengeluid.nl 1
Pastello Pixel Bar 1810
A. GENERAL SAFETY INSTRUCTIONS
This device hasleft the GLG factory in perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in
this user manual.
If the device has been exposed to temperature changes due to environmental changes do not switch it on
immediately. The arising condensation could damage the device.
Leave the device switched off until it has reached room temperature.
This device falls under protection-class 1. Therefore it is essential that the device be earthed. The electric
connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual Make sure the power
cord is never crimped or damaged by sharp edges. If this would be the case, replacement of the cable must be
done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell mayarise.
This is a normal process and does not necessarily mean that the device is defective, it should decrease
gradually.
Fixtures cannot be installed on combustible substances, keep more than 20cm
distance with wall for smooth air flow, so there should be no shelter for fans and
ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
B. UNPACKING
Thank you for choosing our Pastello Pixelbar 1810. For your own safety, please read this manual before
installing the device. This manual covers the important information on installation and applications.
Please install and operate the fixture with following
instructions. Meanwhile, please keep this manual well for future needs.
The Pastello Pixelbar is made of a new type of high temperature strength of
engineering plastics and cast aluminum casing with nice outlook. The fixture is designed and manufactured
strictly following CE standards, complying with international standard DMX512 protocol. It's available
ind
ependently controlled and linkable with each other for operation. And it is applicable for large-scale live
performances, theater, studio, nightclubs and discos.
To Next Page
Need help?
General
