Glide Gear POV 100 - User Manual

POV 100
1
PLEASE NOTE:
 For use with cameras weighing up to 2.5lbs or
1.15kg including the lens
 The POV100 comes in 2 sizes: M (54-60cm/21.25-
23.6”) and L (56-62cm/22-24.4”)
 Recommended use with wide angle lenses set to
innity focus for best results
For more informaon please visit our website: www.glidegear.net
2
Fig A
4
Mount your camera using the screw
inside the slot in the crossbar in the
front of the helmet. See Fig A.
Crossbar
Mounng
screw
3
Included with the POV 100 are 10 weight plates. With
the camera mounted in the front, your head will be
leaning forward. Add weight plates to the back of the
helmet to balance your head and ease the strain on
your neck. Use the supplied thumb nut to secure the
weight plates in an unloose posion. See Fig. B
Fig C
Hint: Weigh your camera and use the appropriate
number of plates to get as close as possible to the
camera weight knowing that 1 plate weighs about
4oz (or 100g).
Example: For a camera weighing 1.6lbs, add 6-7
plates to the back.
Thumb nut
In the rear inside of the helmet, you will nd a knob.
Use the knob to ghten or loosen the helmet’s inside
frame so that the helmet ts ghtly on your head.
The knob in queson is circled on Fig. C.
Fig B

Summary

Camera Mounting and Balancing

Mounting the Camera

Mount camera using the screw inside the front crossbar slot for optimal positioning. Refer to Fig. A.

Adding Counterweight Plates

Add weight plates to the back of the helmet to balance camera weight and prevent neck strain.

Adjusting Helmet Fit

Use the rear knob to tighten or loosen the helmet's inside frame for a snug and secure fit.

Camera Setup and Adjustments

Mounting Possibilities

The POV 100 offers multiple adjustments and mounting possibilities for cameras and accessories.

Adjusting Camera Position

Use mid-section and crossbar knobs to adjust camera position and angle for clear viewing.

Helmet Assembly

Back Plate Mounting

Mount the plate with the longest screw to the back of the helmet using two M3 screws. See Fig. E.

Front Plate Mounting

Mount the curved rectangular plate to the front using two M3 screws through the slots. See Fig. F.

Top Plate Mounting

Mount the rectangular flat plate to the top using two M3 screws through the slots. See Fig. G.

Side Plate Mounting

Mount identical plates to the sides, ensuring the thicker end faces the back of the helmet. See Fig. H.

Glide Gear POV 100 Specifications

General

Brand	Glide Gear
Model	POV 100
Category	Motorcycle Accessories
Language	English