10
Section 4.
Operating your Powerchair.
PG Controller
Your new Power Chair will be supplied with a PG control system as standard unless
otherwise specified. In most cases the Joystick module will be a LCD screen type as per
image below. You will have been given instructions on how to operate your controller at
time of trial and on delivery. As most power wheelchairs are setup with Drive
parameters to suit individuals and needs, we will only cover the basics in this manual.
1. On/Off button (press once for On
again once for Off)
2. Horn
3. Mode Button (select Seating
Functions. Seat Tile or Recline)
4. Profile Button (select Profile - Indoor
or Outdoor drive settings)
5. Speed Button (Sets speed from Low
to High in 5 stages)
6. Joystick (Used to steer wheelchair).
Also used in
More information relating to PG Controller can be viewed at www.glide.com.au
Powered Wheelchairs – CentroGlide - Heading Related Documents - PG Manual.
⚠ Warning
Never push the On/Off button on the Joystick module until you are seated correctly in
the chair. Never try to power-on the wheelchair while the joystick is displaced as you
will receive a joystick error. Joystick must be in the central or neutral position to power-
on. Never use the joystick to hang items,
IMPORTANT: Please familiarise yourself with the individual functions of your
controller in particular the On\Off button. Once for ON and pressing the same button or
pad again for OFF.
To Next Page
Loading...
