CODING INSTRUCTIONS FOR GLIDEROL TM305c REMOTE
www.retroremotes.com.au
0417223200
GLIDEROL TM305c REMOTE
CODING INSTRUCTIONS
CODING REMOTES
GRD
1. Carefully remove cover from control box by lifting tab at bottom
2. Press the receiver button once (located on the receiver board top left corner of control box) A red light will
illuminate
3. Press large button on the handset once and hold until red-light on receiver board turns off - This confirms that the
handset is programmed
GTS
1. Ensuring the power is switched o remove or loosen the screw on the GTS cover using screw driver
2. Remove the GTS cover by pulling in the directions of arrows as shown in the picture
3. Switch ON the power supply and press the LEARN button on receiver once (located on receiver board as shown) •
A red light will illuminate on the receiver board Note: The receiver picture may vary depending on the model of the
receiver compare to the picture shown in the picture
4. Press and hold large button on the handset once until red-light on receiver board turns off - This confirms that the
handset is programmed
To Next Page
Need help?
General
