14
LIFT: Microcurrent Technology
Transmits microcurrents on the skin to tone and firm the face. Must be used with conductive gel. Apply conductive gel on your skin, and spread it evenly over
the area you want to treat. It will beep every 10 seconds. Massage the skin until it is completely absorbed. IMPORTANT NOTICE: DEVICE AND HEAD MUST BE
COMPLETELY DRY BEFORE STARTING THE TREATMENT. Avoid thyroid area.
• I) Press the power button for 2 seconds to activate the
device. The lights below the push button indicate the
intensity level of the treatment, which can be adjusted
by turning the selector vto adapt it to your sensitivity.
• II) Lightly press the two metal rings of the microcurrent
head on the areas to be treated, slide it following the
indications in the image. Check that the two metal rings
are touching your skin. Slowly slide the device with
upward movements until you hear a beep (10 sec), and
press lightly for optimal results.
• III) When you finish your treatment, press the power
button for 2 seconds to turn off the device. If you
wish, you can apply your favorite facial care products
afterwards.
• Remove any conductive gel residual.
To Next Page
Loading...
