EasyManua.ls Logo

GLOBAL PLASMA SOLUTIONS GPS-2400 User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
GLOBAL PLASMA SOLUTIONS
MODEL - GPS-2400
Installation, Operation & Maintenance Manual
MODEL VOLTAGE/VA (max)
GPS-2400-1 115 VAC / 10VA
GPS-2400-2 208-277 VAC / 10VA
GPS-2400-3 24 VAC / 10VA
Mechanical Installation
1. Find a suitable location in the air stream. The optimal location is after a prefilter, but before the cooling
coil. The unit can also be mounted in the supply air. The normal mounting location is the inlet to the fan, see
Fig 1.
2. Using a self-tapping sheet metal screw, mount the GPS-2400 such that air will flow across the carbon fiber
needles simultaneously, like a football through a field goal post. See air flow direction shown. Unit can
mount in any position/angle.
DO NOT:
1. DO NOT MOUNT THE UNIT SO THE CARBON FIBER BRUSHES ARE LESS
THAN 1 INCH FROM ANY METAL, WIRES OR GROUNDED OBJECTS.
2. DO NOT ALLOW THE POWER WIRES TO LAY NEAR OR TOUCH THE BRUSHES
FIG. 1
Airflow
KEEP ALL WIRES AWAY FROM THE CARBON FIBER BRUSHES
ALLOW AT LEAST 1 INCH OF SPACING BETWEEN THE CARBON FIBER
BRUSHES AND ANYTHING METAL OR GROUNDED
THE INSTALLER MAY USE A WIRE TIE OR ELECTRIC TAPE TO HOLD THE
POWER ENTRY WIRES DOWN TO THE SIDE OF THE GPS-2400 BOX
The GPS-2400 is a versatile
product and can mount in any
HVAC system. The GPS-2400
is designed for airflows from 0
to 2,400 CFM or 0 to 6 tons of
cooling.
Question and Answer IconNeed help?

Do you have a question about the GLOBAL PLASMA SOLUTIONS GPS-2400 and is the answer not in the manual?

GLOBAL PLASMA SOLUTIONS GPS-2400 Specifications

General IconGeneral
BrandGLOBAL PLASMA SOLUTIONS
ModelGPS-2400
CategoryAir Cleaner
LanguageEnglish

Summary

Mechanical Installation Guide

Mounting and Airflow Placement

Guidance on selecting a suitable location for mounting the unit within the HVAC system for optimal airflow.

Critical Installation Safety Precautions

Essential warnings regarding spacing from metal/grounded objects and securing power wires near brushes.

Wiring and Operation Procedures

Wiring Instructions and Model Voltage

Details on wiring the GPS-2400 based on model number and voltage, including safety warnings.

Unit Powering and Output Verification

Instructions on powering the unit and confirming its operational status and plasma output.

Maintenance and Warranty

Carbon Fiber Brush Cleaning

Procedure for gently cleaning carbon fiber brushes to maintain optimal cold plasma output.

Product Warranty Information

Details on the GPS-2400 product warranty, coverage, and claim procedures.