To Next PageTo Next Page
Need help?Do you have a question about the Global Water Solutions PressureWave and is the answer not in the manual?
General| Brand | Global Water Solutions |
|---|---|
| Model | PressureWave |
| Category | Tank Equipment |
| Language | English |
Tank must be installed by a qualified professional following local codes. Annual inspection is required.
Tank designed for max 150 psi, 194°F. System needs relief valve (100 psi max). Pre-charge adjustment caution.
Install in covered, dry area, protected from freezing. Prevent water damage and ensure drainage.
Intended for potable water only. Aggressive water conditions may affect performance.
Product contains chemical known to cause cancer/birth defects per California law.
Avoid adjusting pre-charge if tank is corroded. Do not adjust while system is pressurized.
Steps for adjusting pre-charge before or after installation, including safety precautions.
Lists necessary tools (pliers, wrench) and accessories (valves, fittings) for tank installation.
Select a suitable covered, dry location, protected from freezing and vibration, with drainage.
Steps for replacing an existing tank, including draining, closing water flow, and checking fittings.
Instructions for correctly connecting the pressure tank to the water supply and pump system.
Procedure for safely starting the system, purging air, and inspecting for leaks after installation.
Guidance on installing multiple tanks to ensure equal pre-charge, balanced pressure, and proper system function.
General maintenance for PressureWave™ tanks, including annual checks and inspection of accessories.
Critical safety warning to release all water and air pressure before disassembling any tank component.
Details warranty coverage, conditions, and specific exclusions that may void the warranty.
Outlines limitations on GWS USA's liability and procedures for submitting a warranty claim.
Section for recording essential tank and installation details for future reference and warranty purposes.
