Globus Genesy 3000 User Manual

11
REV.01 del 06.12.2017
CONNECTIONS
Cable connection outlets and power supply
Attention:
If the package, the cable or the connector of the charger show signs of wear or
damage, replace it instantly.
Device
Power supply by electricity grid. Genesy 3000 can operate also connected to the
mains 115-230 V. To connect the power supply to the connector, plug it as shown
below (see how to charge the batteries).
To isolate the charger from the mains you have to disconnect it from the mains
outlet.
Battery: how to charge the batteries
The device is supplied with a set of rechargeable nickel-metal hydrate batteries
(12V, 2mAh) which have high performance without storage effect.
Recharge the batteries when the battery indicator on the display indicates ¼.
To charge the batteries, turn off the electrostimulator and disconnect the
electrodes, then connect the elctrostimulator to the power supply unit provided by
inserting the plug in the appropriate inlet (see picture above).
Do not use a different charger from the one provided with the device. To replace
the electrostimulator's batteries, contact the authorized service center.
How to connect the cables
To connect the cables to the device, plug them in the intended inlets in the upper
part of the unit (see picture). Insert the cables with the grooves facing downwards.
The inlets are placed exactly under the corresponding channels.

Globus Genesy 3000 Specifications

General

Brand	Globus
Model	Genesy 3000
Category	Medical Equipment
Language	English