FCCWarning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)This devicemay notcause harmfulinterference, and(2) this devicemust accept
anyinterferencereceived,includinginterferencethatmaycauseundesiredoperation.
Any Changes or modifications not expressly approved by the par
ty responsible for compliance
couldvoidtheuser'sauthoritytooperatetheequipment.
Thisequipmenthasbeen testedand foundtocomplywiththelimitsfor aClassBdigitaldevice,
pursuant topart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotection
againstharmfulin
terferenceinaresidentialinstallation.Thisequipmentgeneratesusesandcan
radiateradiofrequencyenergyand,ifnotinstalledandusedinaccordancewiththeinstructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does ca
use harmful
interferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipment
off and on, the user is encouraged to try to correct the interference by one or more of the
followingmeasures:
‐Reorientorrelocatethereceivingantenna.
‐Increasetheseparationbetweentheequipmentandr
eceiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
‐Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
TheSARlimit ofUSA(FCC)is1.6W/kgaveragedoveronegramoftissue.
DevicetypesA4REVOLUTION(F
CCID:2AC88‐E1)hasalsobeentestedagainstthisSARlimit.The
highest reported SAR values for product specific (Hotspot) are 1.20 W/kg for Main board, 1.18
W/kgforViceBoardrespectively .TheMaxsimultaneousSARare1.39W/kgforMainboard,1.37
W/kg for Vice Board. This device was te
sted for typical body‐worn operations with the back of
the handset kept 10mm from the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 10mm separation distance between the user's
bodyandthebackof thehandset. Theuse ofbeltclips,holstersand similaracce
ssories should
notcontainmetalliccomponentsinitsassembly.Theuseofaccessoriesthatdonotsatisfythese
requirementsmaynotcomplywithFCCRFexposurerequirements,andshouldbeavoided.
CE
Environmental Conditions
Working Temperature -20 ~ 40
℃
Working humidity 65+/-20%RH
Hereby, HONGKONG UCLOUDLINK NETWORK TECHNOLOGY LIMITED,
declares that this 4G Free Roaming Hotspot/ E1, is In compliance with the
To Next Page
Loading...