13
7 On-Roof Installation
7.1 Collector installation
Ensure the mounting brackets are level before securing, see
diagram 7.1.
Position the collector, protective side uppermost, on the
mounting bracket and beneath the clamp, see diagram 7.2.
NOTE: The design is symmetrical and does not have a top or
bottom.
IMPORTANT: Do not remove the protective lm until the
system is to be commissioned
Move the clamp into position ensuring the correct
engagement of both clamps onto the collector.
Secure the clamps.
Diagram 7.1
15177
Diagram 7.2
15178
STRAIGHT EDGE
COLLECTOR CLAMP (UPPER)
MOUNTING
BRACKET
MOUNTING BRACKET
To Next Page
Loading...