Need help?Do you have a question about the Gmade SawBack and is the answer not in the manual?
General safety guidelines for operating RC models.
Safety measures to take before starting model assembly.
Essential checks before operating the RC model.
Important safety warnings during RC model operation.
Essential RC system components like transmitter, receiver, servo.
Batteries, charger, and other power-related items.
Tools provided with the RC model kit for assembly.
External tools necessary for building the RC model.
Assembling differential gears and installing bearings.
Attaching C hub carriers and bevel gears to the axle.
Connecting drive shafts and fitting the differential cover.
Assembling the wheel axle and knuckle arm.
Installing bevel gears and drive shafts in the rear axle.
Mounting leaf spring perches and U-bolts.
Guide for soft suspension, suitable for low speed and high traction.
Guide for standard suspension for normal driving conditions.
Guide for hard suspension for stable handling during high-speed driving.
Attaching the servo plate to the axle housing.
Attaching the servo horn to the servo.
Connecting steering rods and threaded shafts.
Completing the steering linkage with screws and nuts.
Installing counter gears and shafts into the transmission housing.
Mounting the pinion gear and closing the transmission housing.
Attaching the motor plate and setting gear mesh.
Securing the motor plate and gears within the housing.
Connecting universal shafts and U-joints.
Fitting universal shafts into the chassis.
Assembling front leaf spring mounts to the chassis.
Assembling rear leaf spring mounts to the chassis.
Assembling the main chassis frame components.
Attaching body posts and shock stays to the frame.
Installing side step brackets onto the chassis.
Attaching leaf spring bushings to the chassis and axles.
Assembling shock bodies and shafts with O-rings.
Installing shock springs and C-rings.
Mounting the assembled shocks to the chassis.
Securing the front steel bumper to the chassis.
Installing the receiver box onto the chassis.
Installing and adjusting battery plates.
Using ties to secure the battery in place.
Combining tire, wheel halves, and foam.
Sequence for tightening beadlock wheels.
Installing axle pins and wheel hex hubs.
Instructions for cutting the RC car body.
Steps for preparing and painting the body.
Fitting seats, steering wheel, and shifter.
Mounting the windshield, mirrors, and backrests.
Using snap pins to attach the body to the chassis.
Detailed list of all parts with their quantities.
To Next Page
General