4. If the engine does not run after repeating Steps 1
and 2 three times, turn the ignition key off for
60 seconds, allowing the Electronic Control
Module (ECM) to reset.
5. Repeat the above steps until the engine starts.
6. If the engine runs, but does not run smoothly,
increase the engine speed slightly by pressing
the accelerator pedal. This will help to force
out air through the system.
7. If the engine starts and runs but stalls again, turn the
ignition key off for 60 seconds to reset the ECM and
repeat the steps above.
8. When the engine starts, let it idle for a few minutes
and check the filters for any leaks.
Running Out of Fuel
Pickup Models
If the engine stalls and you think that you have run out
of fuel, do this to restart your engine:
{CAUTION:
Diesel fuel is flammable. It could start a fire if it
gets on hot engine parts. You could be burned.
Do not let too much fuel flow from the air bleed
valve, and wipe up any spilled fuel with a cloth.
1. If you are parked on a level surface, add at least
two gallons of fuel. However, if you are parked on a
slope, you may need to add up to five gallons of fuel.
2. Follow the fuel priming procedure earlier in this
section to prime the fuel filter.
3. Close the air bleed valve.
4. Turn the ignition key to START for 10 to 15 seconds
at a time until your engine starts. If the engine tries to
run, but does not run smoothly, increase the rpm a
little using the accelerator pedal. This will help force
air through the system.
5-11
To Next Page
Loading...
