Getting to Know Your Canyon
18
8. Turn the engine off.
9. Place the transmission shift
lever in Park (P), or First (1) for
vehicles equipped with a manual
transmission.
10.Turn the ignition to Lock.
11.Release the parking brake prior to
towing.
Shifting out of Neutral
1. Set the parking brake and press and
hold the regular brake pedal.
2. Shift the transmission to Neutral (N),
or press the clutch pedal for vehicles
with a manual transmission, and turn
the ignition to Run with the engine off.
3. Press the button for the desired
transfer case shift position (2HI,
4HI, or 4LO).
4. After the transfer case has shifted
out of Neutral, the indicator light will
go out.
5. Release the parking brake.
6. You may start the engine and shift
the transmission to the desired
position.
See Section 2 of your Owner Manual.
Shift the transfer case into or out of
Neutral
Shifting into Neutral
1. Set the parking brake.
2. Turn the ignition to Run but leave the
engine off.
3. Press the regular brake pedal and
shift the transmission in Neutral (N),
or depress the clutch for vehicles
with a manual transmission.
4. Shift the transfer case to two-wheel
high.
5. Press and hold the two-wheel high
and four-wheel low buttons at the
same time for 10 seconds. The
Neutral (N) light will come on when
the transfer case shift to Neutral (N)
is complete.
6. Start the engine.
7. Press and hold the regular brake
pedal and shift the transmission to
Reverse (R) for one second; then
shift the transmission to Drive (D) for
one second, or First (1) for vehicles
with manual transmissions and let
out the clutch, to ensure the transfer
case is in Neutral. If not, repeat this
procedure starting at the third step.
Note: Shifting the transfer case to
Neutral can cause your vehicle to roll
even if the transmission is in Park (P) or
in gear. You or someone else could be
seriously injured. Be sure to set the
parking brake before placing the trans-
fer case in Neutral.
Canyon 2008 A 4/3/07 12:36 PM Page 18
To Next Page
Loading...
