GMC 2013 Terrain - License Plate Lamp

Black plate (30,1)
GMC Terrain/Terrain Denali Owner Manual - 2013 - crc 1st edition - 5/8/12
10-30 Vehicle Care
6. Turn the bulb socket
counterclockwise and pull it out.
7. Pull the bulb straight out of the
socket.
8. Install the new bulb.
9. Push the bulb socket in and turn
it clockwise.
10. Reverse Steps 2–5 to reinstall
lamp assembly.
Back–Up Lamp
Removal of the lamp assembly is
not required to replace the back-up
lamp bulb.
To replace one of these lamps:
1. Open the liftgate. See Liftgate
on page 2‑8.
2. Remove the interior trim access
panel.
3. Turn the bulb socket
counterclockwise and pull it out.
4. Pull the bulb straight out of the
socket.
5. Install the new bulb.
6. Push the bulb socket in and turn
it clockwise.
7. Reinstall the interior trim access
panel.
License Plate Lamp
Lamp Assembly
Information Provided by: