Need help?Do you have a question about the GMC ELC2000 and is the answer not in the manual?
Keep work area clean, well lit, and free from flammable materials to prevent accidents.
Ensure proper plugs, avoid contact with grounded surfaces, and protect from rain/wet conditions.
Stay alert, use safety equipment, avoid accidental starting, and dress properly.
Use the correct tool for your application, do not force, and maintain your tools properly.
Run at full revs, position body correctly, grip firmly, and check chain tension.
Use bucking spike as pivot, lift rear of saw, and use central bar for cutting.
Stand opposite, use bar close to chainsaw, and perform cutting operation downwards.
Use syringe to fill hole near bar tip with grease for bearings.
Keep air holes clean to prevent overheating and maintain cooling efficiency.
Avoid operating with intake on ground to prevent foreign particle entry.
Regularly check and clean dust/foreign matter from motor grills and switch.
Wipe with a soft damp cloth and mild detergent. Avoid alcohol or petrol.
Turn the bar periodically to ensure even wear on both sides.
Keep motor cooling vents free from sawdust to prevent overheating.
Periodically clean the guide and oil holes for proper function.
Periodically deburr bar race sides with a flat file to prevent damage.
Even the bar with a flat file if races are uneven and smooth with sandpaper.
Contact customer assist line for repair, service, or advice.
Provide a valid original purchase receipt for repair or replacement.
Provide personal and product details for service requests.
To Next Page
General
