GMC Terrain 2010 - License Plate Lamp

Vehicle Care 9-37
3. Turn the bulb socket
counterclockwise and pull it out.
4. Pull the bulb straight out of the
socket.
5. Install the new bulb.
6. Push the bulb socket in and turn
it clockwise.
7. Reinstall the interior trim access
panel.
License Plate Lamp
To replace one of these bulbs:
1. Open the liftgate partway. See
Liftgate (Manual)
on page 1‑8
or Liftgate (Power) on
page 1‑9
.
Passenger side shown,
driver side similar
2. Push the left end of the lamp
assembly towards the right.
3. Pull the lamp assembly down to
remove from liftgate.
A. Bulb Socket
B. Bulb
C. Lamp Assembly
4. Turn the bulb socket (A)
counterclockwise to remove from
lamp assembly (C).
5. Pull the bulb (B) straight out of
the bulb socket.
6. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install into lamp assembly.