If playing any compatible DVD-R the sound quality may
be reduced due to disc quality, the method of recording,
the quality of the video that has been recorded, and the
way the disc has been handled. There may be an
increase in skipping, difficulty in finding chapters, and/or
difficulty in loading and ejecting. If these problems occur,
check the bottom surface of the DVD. If the surface of the
DVD is damaged, such as cracked, broken, or scratched,
the DVD will not play properly.
If there is no apparent damage, try a known good DVD.
Notice: If you add any label to a DVD, insert
more than one DVD into the slot at a time, or attempt
to play scratched or damaged DVDs, you could
damage the DVD player. When using the DVD player,
use only DVDs in good condition without any
label, load one DVD at a time, and keep the DVD
player and the loading slot free of foreign materials,
liquids, and debris.
Do not add any label to a DVD, it could get caught in the
DVD player. If a DVD is recorded on a personal computer
and a description label is needed, try labeling the top of
the recorded DVD with a soft marker instead.
If an error appears on the display, see “DVD Messages”
later in this section.
Rear Seat Entertainment (RSE)
If the Rear Seat Entertainment (RSE) video screen is
playing a DVD movie and the ignition is turned to LOCK
and then back to ACCESSORY, RUN, or START, the
RSE screen will not turn back on automatically, but you
will hear the audio from the movie. To view the movie
on the RSE video screen:
• Press the remote control O (power) button, then
the
r (play) button, which will continue the
movie from where it was stopped.
• Press the r (play) screen button on the navigation
screen, which will continue the movie from where it
was stopped.
• Eject and replace the DVD movie from the
navigation system, which will start the movie from
the beginning.
3-19
To Next Page
Loading...
Need help?
General
