GMC Yukon - Call Waiting; Receiving a Call

Using the Re‐dial Command
1. Press and hold b g for two seconds. The system
responds with “Ready” followed by a tone.
2. After the tone, say “Re‐dial”. The system responds
with “Re‐dial using <phone name>” and dials the
last number called from the connected Bluetooth
phone.
Once connected, the person called will be heard
through the audio speakers.
Receiving a Call
When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
.
Press b g and begin speaking to answer the call.
.
Press c x to ignore a call.
Call Waiting
Call waiting must be supported on the Bluetooth phone
and enabled by the wireless service carrier to work.
.
Press b g to answer an incoming call when
another call is active. The original call is placed
on hold.
.
Press b g again to return to the original call.
.
To ignore the incoming call, continue with the
original call with no action.
.
Press c x to disconnect the current call and
switch to the call on hold.
4-122