pLease ensure that the repeater is sWitChed off untiL antenna is ConneCted
INSTALLATION
1. To erect the telescopic mast;
• Remove antenna structure from the carry bag and identify whip antenna.
• Unscrew top cap from the top end of the metal housing and attach whip antenna to the smallest telescopic
section, place the metal cap into the bag.
• Grasp the smallest section and extend to stop then twist and pull tightly.
• Continue to extend, twist and pull tightly each section of the antenna till fully extended.
If guy ropes are required, place the guy ring over the thin end of the antenna structure and slide to the larger
sections till locked.
note: Guy ropes/strings are not supplied however any small diameter nylon rope/string may be used if strong winds
are expected. Normally the extended antenna will withstand wind velocities well in excess of 50 knots without the
need for guying however prolonged use in very strong winds may eventually loosen the section grip. If strong winds
are expected over long periods guying is recommended.
2. Slide the coaxial cable tail through the ground stake holding tube and place the extended structure into the
holding tube ensuring that it ts comfortably into the two foam supports (one each end).
3. Attach the N type terminated cable to the repeater before operating the network.
DISMANTLE
1. Leave the extended antenna in the ground stake holding tube, turn
off the repeater and disconnect the coaxial cable.
2. Twist and turn each section slowly collapsing the largest section to the smallest top section.
3. As each stage is collapsed, make sure that the antenna cable is retrieved from the base section to prevent the
cable jamming within the telescopic tubes.
4. If used, remove the guy ring when that section is reached.
5. Remove the top whip section and place into the carry bag then replace the top cap on the top section of the
metal housing.
6. Remove the coaxial cable through the ground stake holding tube.
7. Remove the ground stake and place over the collapsed antenna ensuring that the point faces the non-cable end.
8. Place the structure into the bag.
9. Lay the coaxial cable in loose lengths with each length being the same length as the carry bag.
10. Make sure all antenna parts are accounted for and returned to the carry bag.
11. Secure by zipping the bag.
INFORMATION LEAFLET
AE1000 TELESCOPIC ANTENNA
COMMERCIAL
FOR USE WITH TDR1000
PN: 310649 DN: 47508-2
SUPPLIED WITH
> 1 x 6m telescopic antenna mast.
> 1 x antenna support with ground stake & holding tube.
> 1 x terminated antenna cable (N type connector)
fi xed to telescopic mast.
> 1 x guy ring clip (no guy ropes supplied).
> 1 x soft carry bag for collapsed antenna system.
> 1 x whip antenna section (if ordered with product).
> 1 x information leafl et.
If any items are missing or damaged, please contact your retailer or place of purchase.
To Next Page
Need help?
General
