Termination Boards for Tricon & Tricon CX G.M. International ISM0452-6
4
DIN-Rail clip installation on termination board enclosure
For termination board with 1x or 2 x Plastic DIN-Rail clips TBE-FIX-PL-001, extract each clip and related instruction sheet from plastic bag. Follow the instruction sheet and the following
figures to change lever position (from default to specific for TBE-D50xx-TRI-xxx) on each clip:
Default position
Instruction sheet Changing lever position
Specific position for TBE-D50xx-TRI-xxx
For the termination boards TB-D5016-TRI-010 and TBE-D5016-TRI-010, place the enclosure as shown in the following figures and fix each Plastic or Metal DIN-Rail clip to enclosure
by 2 x M3 (10 mm) screws included on TBE-FIX set:
With 2 x Plastic DIN-Rail clips TBE-FIX-PL-001
With 2 x Metal DIN-Rail clips TBE-FIX-MT-001
For the termination boards TBE-D5016-TRI-001, TBE-D5016-TRI-002, TBE-D5016-TRI-003, TBE-D5016-TRI-004, TBE-D5016-TRI-005, TBE-D5016-TRI-006, TBE-D5016-TRI-007,
TBE-D5016-TRI-008, TBE-D5016-TRI-009, TBE-D5016-TRI-011 and TBE-D5016-TRI-012, place the enclosure as shown in the following figures and fix each Plastic or Metal DIN-Rail
clip to enclosure by 2 x M3 (10 mm) screws included on TBE-FIX set:
With 2 x Plastic DIN-Rail clips TBE-FIX-PL-001
With 2 x Metal DIN-Rail clips TBE-FIX-MT-001
On TBE enclosure must be installed 1 or 2 DIN-Rail clips (according to the model) to be chosen between two possible versions: TBE-FIX-PL-001 (Plastic) or TBE-FIX-MT-001 (Metal).
On TBE order, customer can add TBE-MNT-001 code (for each DIN-Rail clip) to request DIN-Rail clip factory mounting. Otherwise, customer follows DIN-Rail clip installation procedure.
To Next Page
Loading...