If the dash cam is connected with a constant power cable,
won't the car battery discharge?
Our dash cam has a function that automatically turns off when the voltage
value of the car engine is below. The feature, LBP(Low Battery Protector)
prevents car battery discharge and it gives the minimum battery charge rate
so that the driver can activate the engine without failure.
However, in winter, depending on the battery condition and
cold temperature, the car battery may be discharged due to the nature
of the battery. If the battery has been used for more than 2-3 years,
please replace the car battery for safe use.
My car was discharged even though I installed the dash cam with a
constant power cable.
First of all, you need to make sure if the fuse cable connections are installed
correctly according to the instructions. Home users may not be accustomed to
hardwired compared to cigar jack cables. ACC (red) should be connected to
a fuse that is powered when the car engine is turned on.
VCC (= B +) (Yellow) should be connected to a fuse that retains power even
when the car engine is off.
GND (black) should be connected to a bolt that makes physical contact with
the metal surface around the fuse box.
Plus, you need to check the battery life. An aging battery will affect the battery
level. If the problem persists even after testing using both methods, please
contact the seller or manufacturer's customer service center.
46
Q&A
UESTI
N & ANSWE
To Next Page
Loading...
