GO-DEVIL Surface Drive - Special Tools to Service Surface Drives

16
prevent water leakage.
11. Install the Upper Access Panel and lightly tighten the ¼” bolts. Allow Silicone to
cure for several hours and then torque all bolts to 125 In.-Lbs. (10 Ft.-Lbs.)
TOOLS
SPECIAL TOOLS TO SERVICE SURFACE DRIVES
TOTAL $255.00
These tools can be rented for $20.00 plus shipping with a $255.00 deposit.
OTHER TOOLS NEEDED TO SERVICE SURFACE
DRIVES
18” PIPE WRENCH
1/2” DRILL
8” OR 10” CRESCENT WRENCH
1 1/16” SOCKET OR COMBINATION WRENCH
1 1/8” DEEP SOCKET OR COMBINATION WRENCH
PAIR OF CHANNEL LOCK PLIERS
4 TO 5 LB HAMMER
5/16” DRILL BIT
7/8-9 10 TPI DIE NUT
7/8-9 10 TPI TAP
PART #
DESCRIPTION
USED FOR
PRICE
P W2 -3BL
PROP WRENCH
T-BAR TO REMOVE PROP
$50
SHBUPU
PULLER FOR
SHAFT & BUSHINGS
(SLIDE HAMMER)
USED WITH:
SHAFT ADAPTER TO REMOVE SHAFT
BUSHING PULLER- TO REMOVE BUSHING-
(MUST USE 1” TAP TO THREAD INNER
BUSHING FOR BUSHING PULLER INSERTION.)
$50
SHAD
SHAFT ADAPTER
USED WITH PULLER TO REMOVE SHAFT
$15
BUPU
BUSHING PULLER
USED WITH PULLER TO REMOVE BUSHING
$20
BUIN
BUSHING INSTALLER
TO INSTALL BUSHINGS
$10
T1
1” TAP
USED TO THREAD INNER BUSHING FOR
INSERTION OF BUSHING PULLER FOR
REMOVAL OF BUSHING.
$40
R78
7/8” REAMER
AFTER BUSHING INSTALLATION, USED TO
REAM THE BUSHING FOR PROPER SHAFT
PLACEMENT/FIT.
$70