Go Electronic RCC1000 - Select Camera ID; Camera ID Setup; Preset Setup and Recall

2.3 Camera ID setup:
user manual | 10
Sony PTZ camera ID will be set as '1' automatically after powering on.
2.3.1 Camera ID setup for single camera use
Connect camera to controller, press and hold [SetID] for 2 seconds, LCD screen will
display to denote the camera ID has been set as '1'
2.3.2 Camera ID setup for multiple camera use (up to 7)
Connect first camera to controller and subsequent cameras in daisy chain
configuration. Press and hold [SetID] for 2 seconds. LCD screen will display
to denote the camera IDs have been set in sequence as '1', '2', '3'...
2.4 Preset setup and recall:
Preset setup: Select camera ID and press [Preset]. LCD will display
Adjust the camera to desired position and zoom, key in a number for this preset and
press [Enter]. Repeat steps to setup other presets or press [Esc] to exit.
Preset recall: Select the camera ID and press [Call]. LCD will display
Key in preset number and press [Enter]. Repeat steps to recall other presets or press
[Esc] to exit.