Go Rhino dominator d2 series User Manual (English)

To Next Page

QTY PARTS DESCRIPTION

5/16” U-NUTS

6 5/16” X1” HEX BOLTS

6 5/16” LOCK WASHERS

5/16” FLAT WASHERS

18 3/8” x 1 “ HEX BOLTS

3/8” LOCK WASHERS

QTY PARTS DESCRIPTION

3/8” FLAT WASHERS

18 3/8” HEX NUTS

3 C07P PASSENGER MOUNTING BRACKETS

C07D DRIVER MOUNTING BRACKETS

1 D24041P PASSENGER SIDESTEP

D24041D DRIVER SIDESTEP

INSTALLATION INSTRUCTIONS

STEP 1. Read the instructions completely before you begin the installation.

If the vehicle is equipped with factory running boards, remove the fasteners and running boards.

DOMINATOR 2 SERIES SIDESTEPS

ASSEMBLY & INSTALLATION INSTRUCTIONS FOR

PART NO. D24041

07-12 CHEVY/GMC 1500 EXTENDED CAB PICKUP 2/4WD

07-10 CHVEY/GMC 2500HD, 3500 4DR EXTENDED CAB 2/4WD

11-12 CHEVY/GMC 2500HD, 3500HD 4DR EXTENDED CAB P/U 2/4WD (Gasoline only)

Need help?

Do you have a question about the Go Rhino dominator d2 series and is the answer not in the manual?

Go Rhino dominator d2 series Specifications

General

Material	Steel
Installation	Bolt-On
Series	Dominator D2
Mounting Type	Body Mount
Product Type	Side Steps
Finish	Black powder-coated

Summary

DOMINATOR 2 SERIES SIDESTEPS

Parts List

Lists all parts and quantities required for installation, including bolts, washers, nuts, and mounting brackets.

Step 1: Preparation

Read instructions completely and remove existing running boards if equipped, along with their fasteners.

Step 2: Front Bracket Installation

Install the passenger side front mounting bracket by locating specific holes in the pinch mold and rocker panel.

Step 3: U-Nut Installation

Remove the plastic plug from the rocker panel and install a 5/16" U-NUT in the designated location.

Step 4: Attach Mounting Bracket

Loosely attach the C07P mounting bracket to the rocker panel and pinch mold using 5/16" and 3/8" fasteners.

Step 5: Center and Rear Brackets

Locate holes for center and rear brackets, measure rearward from the front fender bolt, and repeat bracket installation.

Step 6: Attach Sidestep

Position the passenger sidestep and loosely attach it to the mounting brackets using 3/8" hex bolts, washers, and nuts.

Step 7: Tighten Fasteners

Tighten all mounting bracket and sidestep nuts and bolts securely.

Step 8: Install Driver Side

Repeat the entire installation process for the driver side mounting brackets and sidestep.