NOTE:
tf you don?see a menu,, took on the
front panel display to see if the VCR
indicator is fit. tf itls not fit, press the
TV/VCR key on.your remote control
to enter VCR mode.
8,
9.
Set your TV to the same channel used in step
7 above.
Press the MENU key on your remote. You should
see a menu. Set the language and clock at this
time, see page 30. Press MENU again until you
10.
11.
Use your cable converter box to select a channel.
You should get a picture.
You are now ready to use your cable box with your
VCR and TV, You may want to check the TUNER
SETUP menu. The Antenna Source should be set
to TV and the Channel Memory should be set %r
the cable box channel 2, 3 or 4 only. See pages 17
and 35.
4t} DISCOVERTHE DUAL-DECKDIFFERENCE
To Next Page
Loading...
