10
2. Pop the plug into an electrical socket
and turn the power on.
3.
operate the vacuum. Press again to turn
How to…
…use your vacuum
Ensure the vacuum is fully assembled
before using.
1. Pull the power cable from the main unit
by holding the plug. Do not exceed the
red marker on the cable.
Please note
You can set the suction power of the vacuum by sliding the suction regulator
back or forth on the hose handle. We recommend using a low suction power
for delicate materials. To extend the telescopic tube, push the slide button
with one hand holding the wider tube, and slide out the narrow tube to
preferred length.
4. Move the floor head back and forth over the surface. Use even strokes.
Don’t press hard; allow the cleaning to suck away the debris.
To Next Page
Loading...
